It’s a fair question. First, there is no big ground terminal because there is no current flow back to ground needed on the board. We could have added ...
Sorry gents! We have been blessed by orders - so the last video kept getting pushed back. Promise we'll get back on it soon!
Do you have a link to the spec sheet?
Hi, Currently this is not possible. We are working on adding some expanded ability to use other inputs and registers. Scripting it is the best pathw...
Sensors should always index in the same order, so long as they didn't change. We have plans to use hard addresses in the future.
OK good. What was it?
Can you close BruControl, then re-open it. Then email us the "controller.xxxx.log" from the Documents/BruControl/Logs folder? Here, xxxx is the date c...
Higher values would probably help... like a 10uF. That said, multiple values in parallel might help even more, depending on the noise frequency.
Hi. Just tested this, and you are correct! Normal elements update correctly, but for some reason the button is not. Will add this to the bug list. T...
Hi, Sorry for the hassle! Per the Build 15 Beta Product Note, please make sure that all Digital Outputs have a Dual Throw port set to None, rather t...
I think 10 and 20, summing 30 are too low and may overload the sensor output. 1/2k or 2.2/3.3k make more sense to limit the current out of the sensor....
You are correct about the bank of pine that are ADC1, but you don’t need to think about those. We provide documentation about which pins can serve whi...
I'm not too experienced with inline pH meters. Perhaps @DieBeerery or another can answer.
Yes, if your current TD5 does NOT have the front-end circuitry, then you can use a MOSFET board to switch PWM directly from the interface and change (...
Data Exchange makes it possible for applications to contact BruControl to get or push data. This requires the application to initiate the communicatio...