Forum

Remote Reset of Int...
 

Remote Reset of Interfaces  

  RSS

(@natebrews)
Active Member
Joined: 2 months ago
Posts: 11
March 4, 2019 2:41 am  

Is there a way to reset an interface device (Mega/NodeMCU/etc) in the software?  I couldn't figure out a way to do it in software alone.  One way is to have a pull down (2n7000 or such) on the RESET pin that was triggered by some other one shot digital output.

A simpler answer might be a schottky diode (to ensure a good logic level) from RESET to another digital pin that can pull it down, but I don't know if that might cause a startup problem.


Quote
Share: