Hi, I'm Lauran Casteleijn, and I'm testing and debugging the BruControl scripts. I'm using software version 1.1 (22). I'm using the Arduino Mega platform and all runs stable and nicely and I'm getting used to the BruControl interface. I changed from BCS including a hysteresis function that I was used to.

For BruControl, I have looked on the Internet for throubleshooting the hysteresis function but can't get it appropriately running. I have the following questions, please can you help?

1) I'm using version 1.1 (22) should I use Beta version 1.2?

2) I'm using port 18 and 19, DutyCycle is working fine, using port 18 and 19 for Hysteresis not

3) Target setting: 52 degrees, Offset -3 degrees, On delay 3 seconds (I don't exactly understand what will happen, can you please explain?) Predictive Hysteresis, (I don't exactly understand what will happen, can you please explain?)

Thank you in advance for your response, Best regards, Lauran Casteleijn