Posted by: canmorebrewguy I would like to use bru control to run my conical fermenters, my thought is to use a glycol chiller that will have a consent...
So this could work?example:[setup]new time First_Hopnew time First_Hop_Timingnew time Boil_Time[main]Boil_Time = 01:00:00"Step" Type = CountDown"Step"...
I just checked out the spec sheet of that sensor because is looks good and it will operate to 70degC. So Sparging might be an issue at 75degC...
Found the issue... User error of course.... I flashed the boards with ethernet firmware load - not USB. I noticed my interfaces in BruControl were not...
and meant to add, both MEGA boards accepted the BruControl firmware without any problems.
And can you share how you coded or setup the proportional electric valve? is this a 4/5 wire or 3 wire valve you are using for this?
Are you willing to share what flow meter you have used and how you set that up in the brucontrol interface? I am also wanting to know how many outputs...