Forum

Augiedoggy
@augiedoggy
Active Member
Topics: 0 / Replies: 6
Reply
RE: PH probe

this board does also show a temp compensation sensor mounted in the corner.

6 years ago
Forum
Reply
RE: PH probe

I've read it reads accurately between 10 and 30 degrees c and goes up about .01 up to 50c... I dont intend to use it at high temps because it dramatic...

6 years ago
Forum
Reply
RE: PH probe

for the sake of experimentation and because im always game to test the cheap stuff I bought one of these... if it works I will by a better quality ...

6 years ago
Forum
Reply
RE: Welcome to BruControl

homebrewtalk.com in the automated brewing section.

6 years ago
Reply
RE: Use Brucontrol to control glycol chiller and heat for fermenters-Help

I currently do this but I only use a soleniod valve on the inlet side of my glycol manifold I also use silicone heating strips for heat. I use 24v dc ...

6 years ago
Reply
RE: Relay for switching element control

This is what I do... only I use the 16 relay board and use 2 relays for the element power . I use the NC contact one one element relay to interrupt t...

6 years ago
Forum