Attakid!
Three elements is totally normal! We just didn’t make schematics for a three element setup. Its not *that* much different. If you have a rig which wil...
Device states and values are either kept through shutdown or disabled depending on the shutdown confirmation box button you select.
Functionally looks OK. 1-wire can be sensitive to noise... I wouldn't "bus bar" the signal line - keep that short and clean to minimize exposure to th...
The MEGA has internal pull-up resistors, so if you select active-low for an input, you can switch ground and it will work fine. If you select active h...
Active high or low refers to the voltage state of an input or output when the device is considered ON. For example, if you put 5V to an input pin, it ...
You do not edit script files in the folders. In fact, you never need to look in those folders. The application will hold all the scripts you put in it...
Definitely true that for automation, some script implementation is needed. One thing to think about BC's difference from BCS is that the BCS operates ...
Hi oakbarn, The interfaces (MEGA in this example) do not run the scripts - these run on the computer. And for the record, you don't need to run any sc...
Discussed live... GPIO 0 has issues... will be fixed!
Yes, they run independent of each other but are all controlled by BruControl. So to you, the user, it’s all transparent. For example when you or a scr...
Hi @oakbarn... there is no master/slave arrangement for interfaces. In BruControl, the computer running the application is the master, and the interfa...
Yes. If you acquired an interface yourself, you will need to install the firmware into it before connecting it to BC.
Yes. If you acquired an interface yourself, you will need to install the firmware into it before connecting it to BC.
Wow, that’s totally unreasonable. How would they know behind the router though? I suppose if it’s their router but a normal one should blind the exter...