What I think you were saying: PID on a "D" is fine even with a cheap SSR. Do not put PID Control on a "P" unless you have the proper Proportional S...
So the BCS does not have a True PID. Interesting. When running a heating Element, Should I use PID control on a "D" Pin with a Standard SSR or ch...
I still do not understand PWM. I thought I did. Again most of my information is from my BCS build. In that, PID, Hysteresis, and Duty Cycle were on...
I got my Ethernet working! Time to switch the wiring and start scripting.!!!! 😀 😀 😀 😀 😀 😀 I did not quite understand the wiring map because o...
I have read the user manual at least 10 times. I quite understand what a Device Element is. I understand the “name” and most other attributes of a ...
in your sample code you have the following: "Water Input" Enabled = false"Boil Temp" Enabled = false"Chill Temp" Enabled = false"Chill Flush" Enabled ...
I thought I had two questions but figured out the first one by myself. I was doing some resting and added a button for Port 13. It would not give me...
Not sure what I did but I think I set a static ip. Regardless, I was trying to reset the network as I think I got it wrong. When I get to the Termit...
Ok Found the issue. I thought that GW might be Gateway but it looked like only 4 digits. It was the format of the Mac Address. It is sort hiding...
It is a Different RobotDyn Mega I am working on. I used a generated Address that I did not see on ARP -a. It says mac invalid. I proceeded. Not ...
Not sure what you mean by "one in the test report for consistency" ? What "test report"? I will try one from a Mac Address generator.
Partially found my answer. Code is "%0&15;"! But now I am stuck at the MAC Address: There is no MAC address on the Mega with on Board Ethernet...
I thought I would expand on the answer a little as it was a question I had. I was used to the BCS and it has a finite number of Outs, Ins, and Probes...
I think I have my hardware plan down. I think I need to order another TF3 Board so as not to have to rewire our Sensors. They run from the controlle...
I figured it out. Dreaded space at the end of a name: "MashTimer " vs "MashTimer" "MashTimer " Visibility = Hidden would have worked. It was the nam...