Topic starter October 11, 2022 2:35 pm
I am setting up, hopefully, three flowmeters on my controller. Two are setup using counter inputs on ports 2 and 3 in BruControl. Is the the correct way to start? Are there any more counter inputs?
I will have to calibrate the flowmeters but I'm not sure where to start. When pour a cup of water through to test them, BruControl counts between 100 and 150 "units" of measurement. How do i translate that into a volume of liquid?
Thanks in advance?
Topic starter October 13, 2022 3:51 pm
I went back through the forums and found the one about linear multipliers for calibrating flowmeters. Sorry.