It's not. If you search on it, you will likely find a solution. Check the Adafruit forums.
For some reason the updater has not been working with the MEGA or UNO recently. We have had to update using different boards like the Metro M4. ...
No, sorry. That may be an artifact in the manual (I'll check). Pin 5 was always used until the Wi-Fi shield on the MEGA was implemented... in which ca...
Pretty high!
Another program is accessing the COM port simultaneously... do you have the Terminal (termite) open too?
Can look. We think if you have many screens it's best to put them on the BruControl workspaces, but understand the desire for local information someti...
How many amps is your supply? You can modify the schematic to remove one of the legs (for example L2 or the red lines) and reference everything to Neu...
Can you explain what you mean by "international"? Are you looking for 3 phase, or a different voltage?
Do you mean temperature sensors? Or other types? We support RTD, thermistor, 1-wire, and temp sensors. For other types, currently look for analog outp...
The current module you linked outputs DC voltage commensurate with the current being used - very easy to wire in. However, voltage sensing is a bit tr...
Hi, Yes, that configuration will work. You seem set on 1-wire, so go for it.
The ESP8266 that the Node MCU is based on only has one analog input - that isn't enough. The Feather has 5. Alternatively, you could use the ESP32... ...
I would suggest you do this in "modules". This would allow you to integrate over time, which will minimize your risk. Build an initial control box... ...
Hi Matt, You can certainly do what you are looking for. I would actually recommend you stay with the thermistors - these will work well. We also have ...
I'm not sure the benefit of pneumatic drive other than tri-clamp body. If that's your goal... go for it. Otherwise, I'd stick with electric motor driv...