Got it within 3.2 mV (there was a 87 mV difference initially). I suspect that is close enough 🙂
OK, I'll check it out. It is a average Meanwell PSU but voltage has looked good and steady so far. I used in my previous BCS panel without issue.
I was just removing the whole concern around drawing too much current through the MEGA by doing it that way. In my scenario, is there a modified way t...
1. No info to provide yet but I can try to get some. 2. It hasn't with regularity. Perhaps on occasion but I can't recall. 3. Even if the Mega is no...
I have seen this behavior with the MEGA not "powering up" properly occasionally in terms of of what I estimate to be the Ethernet portion. I have fou...
There is no reason TF3 board outputs can't be used on A0 or any other analog input. I have hooked up analog inputs indiscriminately. Analog, is anal...