Forum

thesleepydog
@thesleepydog
Active Member
Topics: 2 / Replies: 7
Reply
RE: Use Brucontrol to control glycol chiller and heat for fermenters-Help

Posted by: canmorebrewguy I would like to use bru control to run my conical fermenters, my thought is to use a glycol chiller that will have a consent...

6 years ago
Reply
RE: formulas with the time variable

So this could work?example:[setup]new time First_Hopnew time First_Hop_Timingnew time Boil_Time[main]Boil_Time = 01:00:00"Step" Type = CountDown"Step"...

6 years ago
Forum
Topic
Forum
Replies: 5
Views: 3821
Reply
RE: Flowmeter vs flow switch

I just checked out the spec sheet of that sensor because is looks good and it will operate to 70degC. So Sparging might be an issue at 75degC...

6 years ago
Forum
Reply
RE: No Voltage out on Digital Pins - Arduino Mega

Found the issue... User error of course.... I flashed the boards with ethernet firmware load - not USB. I noticed my interfaces in BruControl were not...

7 years ago
Forum
Reply
RE: No Voltage out on Digital Pins - Arduino Mega

and meant to add, both MEGA boards accepted the BruControl firmware without any problems.

7 years ago
Forum
Topic
Forum
Replies: 3
Views: 5665
Reply
RE: Brewery Code

And can you share how you coded or setup the proportional electric valve? is this a 4/5 wire or 3 wire valve you are using for this?

7 years ago
Forum
Reply
RE: Brewery Code

Are you willing to share what flow meter you have used and how you set that up in the brucontrol interface? I am also wanting to know how many outputs...

7 years ago
Forum