RoatanBill
Active Member
Follow
RE: Getting closer to finishing my design
The motors to lift the kettles are chain coupled to 3/4" acme thread screws that will raise them up at about 12"/minute depending on the large sprocke...
7 years ago
Forum
RE: Getting closer to finishing my design
Water will dribble into the HLT from a reverse osmosis system. All water here is well water so a filter is needed for everything. I want to automate t...
7 years ago
Forum
RE: Getting closer to finishing my design
Yes, I have drawings, but I see no way to upload them to your site. As I type this, I see the available controls, and none appear to offer a file uplo...
7 years ago
Forum
RE: Getting closer to finishing my design
I want to get to your level of automation, so I'd like to know if I've identified all the holes in the kettles for all the normal hose and electrical ...
7 years ago
Forum